Konica Minolta CF5001 Service Manual page 203

FN-9/FN120 Ver.1.0 Sep 2003
6. Fasten the wire bracket [1] tentatively to the up/
down stay [2] with 2 screws [3].
Note:
• Be sure to set the up/down wire [4] with the
shorter section [5] up and the longer section
[6] down.
7. With a new up/down wire fastened to the wire
end [2] of the up/down pulley /L [1], wind the
wire a little less than 5 turns from inside toward
outside around the pulley without getting loos-
ened and set the up/down pulley /L [1] to the
shaft so that it is in tune with the pin [3].
8. After putting the up/down wire on the up/down
pulley /U [1], wind it 2 turns from inside toward
outside around the up/down pulley /L [2] without
getting loosened and fasten it to the wire end
[3].
[6]
[4]
[1]
[5]
[1]
[1]
[3]
[2]
1-173
[2]
[3]
fs2153025
[3]
[2]
fs2153026
fs2153027