Replacing The Fixing Temperature Sensor /4, And Removing And Reinstalling; The Fixing Temperature Sensor /2 And The Thermostat /L - Konica Minolta CF5001 Service Manual

Konica minolta cf5001 laser mfp service manual

Hide thumbs Also See for CF5001:

Table of Contents

CF5001 Field Service Ver.1.0 Sep 2003

Replacing the fixing temper-

ature sensor /4, and remov-

ing and reinstalling the fixing

temperature sensor /2 and

the thermostat /L

• After reinstalling the fixing temperature sen-

sor /4, be sure to check that the sensor sec-

tion is in touch with the fixing roller. If not, the

temperature control may go abnormal or the

fixing temperature sensor /4 may detect the

low fixing temperature abnormality.

• Be sure to check that the wiring harness is

not in touch with the fixing roller.

• The thermostat /L is an essential safety part.

Be sure to follow the cautions and steps

given below when removing and reinstalling.

• After completion of the installation of the

thermostat /L, be sure to check that the wir-

ing harness is not in touch with the fixing

lower roller.

• Be sure to fasten the thermostat /L after posi-

tioning it properly with a positioning jig

(4969-1886-01). Be sure to apply screws with

screw lock paint. And also be sure to conduct

this adjustment under the pressure-released

condition and the temperature low condition

of the fixing roller /L.

A. Periodically replaced parts/cycle

• Fixing temperature sensor /4: Every 2,500,000