Stitch And Fold Stopper Adjustment (Fn-9 Only); Fold Stopper Adjustment (Fn-9 Only) - Konica Minolta CF5001 Service Manual

CF5001 Field Service Ver.1.0 Sep 2003
7.8.1 Stitch and fold stopper adjustment (FN-9
only)
Adjusting the stapling position when stitch and fold
mode.
A. Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [7. Finisher adjustment] key.
3. "Finisher adjustment mode menu screen"
Press the [1. Stitch and Fold stopper adj.] key.
4. "Stitch and Fold stopper adj. (A3) screen"
Press the [COPY SCREEN] key.
5. Set paper in the tray, set originals on RADF,
and press the START button.
6. Check the paper center and stapling position.
• Standard value: ± 1mm
7. When the value is not within the standard,
press the C button while pressing the P button.
8. "Stitch and Fold stopper adj. screen"
Press the [NEXT ADJUSTMENT] or [PREVI-
OUS ADJUSTMENT] key to select a desired
paper size.
9. Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -128 to +127, 1 step = 0.1 mm
10. Repeat steps 4 to 9 until the standard value is
obtained.
11. Press the [PREVIOUS SCREEN] key to return
to the "Finisher adjustment mode menu
screen."

7.8.2 Fold stopper adjustment (FN-9 only)

Adjusting the fold position when stitch and fold or
folding mode.
A. Procedure
1. Enter the 36 mode.
2. "36 mode menu screen"
Press the [7. Finisher adjustment] key.
3. "Finisher adjustment mode menu screen"
Press the [2. Fold stopper adjustment] key.
4. "Fold stopper adjustment (A3) screen"
Press the [COPY SCREEN] key.
5. Set paper in the tray, set originals on RADF,
and press the START button.
6. Check the paper center and folding position.
• Standard value: ± 1mm
7. When the value is not within the standard,
press the C button while pressing the P button.
8. "Fold stopper adjustment screen"
Press the [NEXT ADJUSTMENT] or [PREVI-
OUS ADJUSTMENT] key to select a desired
paper size.
9. Enter a numeric value through the numeric
keys and press the [SET] key.
• Setting range: -128 to +127, 1 step = 0.1 mm
10. Repeat steps 4 to 9 until the standard value is
obtained.
11. Press the [PREVIOUS SCREEN] key to return
to the "Finisher adjustment mode menu
screen."
2-101
36 MODE