Table of Contents
Advertisement
5.3
Replacing the stapler
A. Periodically replaced parts/cycle
• Stapler: Every 200,000 staples
Note:
• Do not use hands to move stapler units to
horizontal direction.
Otherwise the belt and the gear teeth skipping
may occur.
• After reinstalling the clincher, be sure to con-
duct the "vertical adjustment of the FNS sta-
pler." (See "ADJUSTMENT.")
B. Procedure
1. Open the finisher door.
2. Pull out the stacker unit.
3. Remove the cartridge from the stapler.
4. After removing 4 screws [2] of the stapler /F [1]
and a ground screw [3], take out the stapler /F
[1] and remove the connector [4].
[1]
[2]
[3]
1-182
FN-9/FN120 Ver.1.0 Sep 2003
[2]
[4]
fs2153043
Advertisement
Table of Contents
