Table of Contents
Advertisement
OTHER ADJUSTMENTS
9.15 FNS adjustment of the sta-
pling position (flat stapling)
(only for FN-9)
A. Procedure
Note:
• Never move the stapler unit in a horizontal
direction manually (it may cause teeth to skip
between the belt and gear).
1. Perform a stapling operation to check whether
the paper edge and the line [2] connecting 2 sta-
ples [1] becomes parallel [3] and the discrep-
ancy L is within the standard value.
Standard value: discrepancy L = 1 mm or less
If the discrepancy is not within the standard
value, perform the following adjustment.
2. Check whether "adjustment of the position of
FNS alignment plate/U" and "adjustment of the
position of alignment plate/L" has been com-
plete.
3. Open the finisher door and pull out the stacker
unit.
4. Remove the rail stopper screws for the stacker
unit. Then, pull out the stacker unit further.
Note:
• To avoid the finisher from falling, make sure to
place a support under the stacker unit.
5. Remove the stapler unit cover.
6. Loosen 3 screws [2] for the alignment plate/L
[1].
CF5001 Field Service Ver.1.0 Sep 2003
[3]
2-156
[1]
[2]
L
8050fs1103
[1]
[2]
8050fs1104
Advertisement
Table of Contents
