CF5001 Field Service Ver.1.0 Sep 2003
9.31 Adjusting the tilt of PI (when
PK punch is used)
A. Preparation
1. Check the following items:
• PI is connected to FNS.
• The tray of PI is loaded with paper.
2. Check the tilt of output paper in advance.
• Feed 3 sheets from PI with the Punch mode
selected to check the tilt of punch holes.
3. Loosen one screw securing the guide plate.
B. Procedure
1. Fold each of the fed 3 sheets into two as illus-
trated below and find out in which direction the
punch holes tilt.)
Tilting toward
the right edge
of the sheet
2. Open the FNS front cover.
3. Loosen one screw securing the guide plate.
Tilting toward
the left edge
of the sheet
7165field142i
2-181
4. Using the mark as a guide, move the guide plate
laterally by the amount of tilt in the position of
punch holes.
Tilting toward
the right edge
of the sheet
5. Retighten the screw securing the guide plate.
6. Repeat steps 1 to 5 until the amount of tilt in the
position of punch holes is improved.
OTHER ADJUSTMENTS
Screw securing
the guide plate
Tilting toward
the left edge
of the sheet
7165field143i