Exiting Isw Trns - Konica Minolta CF5001 Service Manual

CF5001 Field Service Ver.1.0 Sep 2003
2.4.9

Exiting ISW Trns.

When the update of the ROM data on the con-
trol boards completes, exit the ISW Trns pro-
gram.
Step
1 Exit the ISW Trns program.
2 Turn OFF the PC.
3 Turn OFF the copier main switch.
4 Disconnect the parallel interface cable
from the PC and the copier.
Note:
• Turn OFF the PC and copier before dis-
connecting the parallel interface cable
from them.
Procedure
2.4.10 Verifying the ROM version of the copier
(after updating)
When the update of the ROM data completes,
verify the ROM version of the control program
in the 25 mode.
Step
1 Turn OFF the copier main switch.
2 Turn ON the copier main switch while hold-
ing down the copy count setup buttons 2
and 5, to enable 25 mode.
3 [25 mode menu window]
Check the ROM version by following the
copier-specific procedure.
Note:
• For operating instructions, refer to the
Adjustment section of the service man-
ual supplied for the copier.
3-19
UPDATING WITH ISW Trns
Procedure