Fns Adjustment Of The Position Of Alignment Plate/L (Only For Fn-9) - Konica Minolta CF5001 Service Manual

Konica minolta cf5001 laser mfp service manual

Hide thumbs Also See for CF5001:

Table of Contents

OTHER ADJUSTMENTS

9.12 FNS adjustment of the posi-

of alignment plate/L

(only for FN-9)

A. Procedure

1. Check whether "Adjustment of the position of

FNS alignment plate/U" has been completed.

2. Turn on the main body. In the 47 mode, use one

of the following codes to drive a motor and turn

off the main body.

• Code 75-8: alignment motor/U (M705) home

position search

• Code 75-21: alignment motor/L (M716) home

position search

• Code 75-39: stopper motor (M718) moves to the

A4R or larger position

3. Open the finisher door and pull out the stacker

4. Remove the rail stopper screws for the stacker

unit. Then, pull out the stacker unit further.

• To avoid the finisher from falling, make sure

to place a support under the stacker unit.

5. Remove the stapler unit cover.

6. Check whether the actuator for the alignment

HP sensor/U (PS708) is aligned with the home

7. Check whether the actuator [3] for the alignment

HP sensor/L (PS724) for the alignment plate/L

[1] is aligned with the home position.

CF5001 Field Service Ver.1.0 Sep 2003