Replacing The Double Feed Prevent Roller And Torque Limiter - Konica Minolta CF5001 Service Manual

Paper feed unit
4. When replacing the paper feed roller and feed
roller for the lower tray, open the upper tray and
perform the steps 2 and 3.
5. Reinstall the above parts following the removal
steps in reverse.
Note:
• Ensure that the mounting direction of each
roller and rubber is correct.
2.2 Replacing the Double feed
prevent roller and Torque
limiter
A. Procedure
1. When replacing the double feed prevent roller
and the torque limiter for the upper tray, detach
the top cover.
2. Detach the paper feed roller unit.
3. Release the hooks on both sides, remove the
double feed prevention roller assembly by lifting
up, then pull out the shaft, and remove the dou-
ble-feed-prevention roller together with the feed-
reverse gear.
4. Separate the double feed prevention roller and
the torque limiter from the double feed preven-
tion roller assembly.
5. When replacing the double feed prevention
roller and the torque limiter for the lower tray,
open the upper unit and perform the steps 2 and
3.
6. Reinstall the above parts following the removal
steps in reverse.
Note:
• Ensure that the mounting direction of each
roller and rubber is correct.
Cover Inserter D Ver.1.0 Sep 2003
Top cover
Hooks
Stop rings
Double feed prevention roller
Notch
1-192
Release lever
Double-feed prevention roller
Torque limiter