Upgrading The Firmware On The Main Pwb; Firmware Program Data Format - Kyocera FS-1030D Service Manual

1-7-1 Upgrading the firmware on the main PWB

Updating the system (controller) firmware is possible by downloading the firmware through the parallel interface or through
the memory card (CompactFlash). These firmware programs are directly overwritten in the system DIMM (Flash ROM type
only) on the main PWB. The operation panel message in different languages can also be downloaded through the parallel
interface or through the memory card.

(1) Firmware program data format

System firmware
The data to be downloaded are supplied in the following format:
Software ID
Product code 2G6: This printer
Pause (under bar)
S 2 G 6 _ 3 0 0 0 0 0 1 0 2 1 . c m p
Figure 1-7-1 Firmware program data format
Build number
Version up history
0: Normal
E: Corrective
Destination
Firmware description (supplement)
Firmware description 1: Engine controller
2: MFP controller
3: Printer (Main) controller
4: Facsimile
5: NIC
6: Operation panel message language
7: Panel language
Compression
Pause (period)
2G6
1-7-1