Network Critical SmartNA-X User Manual page 97

C L I R
OMMAND INE NTERFACE EFERENCE
S IP 6
ET V STATIC
Use the set IPv6 static command to configure a static IPv6 network address, prefix length, and optionally a
gateway address. SmartNA-X has a link-local IPv6 address implicitly set, but you may specify one additional IPv6
address. The new configuration will not be implemented until you log out (exit) from the CLI.
Command form set IPv6 static <IPv6-addr> <prefix-length> [gateway <IPv6-gateway>]
IPv6-addr
prefix-length
gateway <IPv6-gateway> (Optional) Specifies the network gateway IPv6 address.
Examples Configure the following static IPv6 network settings:
IP address: 2001:db8::52:0:21
Prefix length: 64-bits
Gateway: 2001:db8::52:0:10
CONTROLLER>set ipv6 static 2001:db8::52:0:21 64 gateway 2001:db8::52:0:10
|
Specifies the network interface IPv6 address, in standard IPv6 format, such as
2001:db8::52:0:1
Specifies the network prefix length. The value must be in the range 16–124.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
92