C
L
I
R
OMMAND
INE
NTERFACE
EFERENCE
S
ET FILTER ARP
Use the set filter arp command to create a filter for ARP (Address Resolution Packets) packets. If no other
conditions are specified, the filter matches all ARP packets. Additional conditions can be specified to further refine
the match conditions. For example, specifying the VLAN number limits matches to those ARP packets which have
the specified VLAN header information. Multiple conditions can also be specified where all conditions must be
satisfied before a filter is considered a match. Packets matching an applied filter will either be passed or dropped,
depending the criteria specified in the set map command.
Command form
set filter name-string arp [arp-conditions ...]
name-string
arp-conditions
|
Specifies the filter name. It may contain spaces, but if it does, it must be contained in
quotes "..."; the name itself may not contain the quotes character.
(Optional) Provides additional filtering conditions for the specified protocol. All
conditions must be satisfied for the filter to match. For ARP packets, the following
additional filtering conditions can be specified:
[
vl-value] (Optional) Filters on the specified value matching the VLAN number.
vlan
For vl-value, the following formats are recognized:
• 100 – A single tag
• 100–110 – A range (inclusive)
• 0/1 – A value/mask pair (here: all even tags)
• 100,150 – Multiple tags. Use commas (no spaces) to separate VLANs.
[
mac-value] (Optional) Filters on the specified value matching the source
mac src
MAC address. For mac-value, the following formats are recognized:
• 01:23:45:67:89:ab – A single address
• 01:23:45:67:89:ab,01:23:45:67:89:ac – Multiple addresses. Use commas (no
spaces) to separate addresses.
[
mac-value] (Optional) Filters on the specified value matching the
mac dest
destination MAC address.
[
mac-value] (Optional) Filters on the specified value matching either the
mac either
source or destination MAC address.
S
NA™ 10G N
MART
DRAFT
A
(S
NA-X)
ETWORK
CCESS
MART
147
Need help?
Do you have a question about the SmartNA-X and is the answer not in the manual?