Network Critical SmartNA-X User Manual page 77

C L I R
OMMAND INE NTERFACE EFERENCE
S
ELECT
Use the select command to select the system Controller (motherboard) or a chassis slot. Selecting a slot will give
you access to the TAP module that is installed in the slot and allow you to view and configure its ports.
Command form select slot [0-4]
select controller
SlotNumber
Examples • Select slot 1 (left slot):
CONTROLLER>select slot 1
SLOT1>
• Select slot 0 (rear ports):
CONTROLLER>select slot 0
SLOT0>
• Select Controller:
SLOT1>select controller
CONTROLLER>
|
Specifies the chassis slot number. Front slots are numbered 1–4 (left to right); rear
ports are slot 0.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
72