Et Port Autolock - Network Critical SmartNA-X User Manual

C L I R
OMMAND INE NTERFACE EFERENCE
S

ET PORT AUTOLOCK

Use the set port autolock command to configure auto locking on the specified ports of the currently selected TAP
module. To prevent unauthorized users from accessing ports, you can set autolock so the port becomes
automatically locked if the cable is removed, preventing data transmission to/from the port. Once a port has
become locked, use the port lock off command to unlock it.
Command form set port port-id autolock {
port-id
|
on off
Examples • Enable autolock for port 4C:
SLOT4>set port C autolock on
SLOT4>show port C
speed
duplex
mdi
mastering
tap
autolock
lock
usage
port type
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
• Disable autolock for port 4D:
SLOT4>set port D autolock off
SLOT4>show port D
speed
duplex
mdi
mastering
tap
autolock
lock
usage
port type
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100
|
| }
on off
Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
Sets the port autolock to on or off. Off is the default setting for all ports.
: set 1G
: set auto actual full
: set mdi-x
: set preferslave
: off
: on
: off
: undefined
: Registered Jack 45 (RJ45)
: set auto
: set auto actual full
: set mdi
: set preferslave
: off
: off
: off
: undefined
: Registered Jack 45 (RJ45)
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
127