Network Critical SmartNA-X User Manual page 202

W U -I R
EB SER NTERFACE EFERENCE
Table B-6 Options for configuring SNMP Users
Option
User name
Engine
Authentication
Privacy
Table B-7 Options for configuring view-based communities (SNMP v3)
Option
Community string
IP version
Source
Security name
Table B-8 Options for configuring view-based groups (SNMP v3)
Option
Group name
| SNMP
TAB
Description
Specify a name for the user. Names consist of 1–32 alphanumeric characters, and must begin with a letter.
You may define local users (for most uses) and remote users (for use with sending SNMPv3 informs). If
this is a remote user, you must also specify the corresponding remote engine ID.
If setting up a remote user, you must specify the engine ID of the remote SNMP agent. Engine IDs
consists of 10–64 hex digits.
Specify whether authentication is to be used, and if so whether to use MD5 or SHA authentication.
If authentication is in use, you must also specify a passphrase in the Authentication phrase field that
appears. Authentication phrases must be 8–64 ASCII non-control characters.
For users already set up on the device, either enter a new passphrase if you wish to make a change or leave
this field blank to keep the existing passphrase.
Specifies whether encryption is to be used, and if so whether to use DES or AES.
If encryption is in use, you must also specify a passphrase in the Privacy phrase field that appears. Privacy
phrases must be 8–64 ASCII non-control characters.
For users already set up on the device, either enter a new passphrase if you wish to make a change or leave
this field blank to keep the existing passphrase.
Description
Specifies a community string for the community. The string must consist of 1–32 alphanumeric
characters, and must begin with a letter.
Specifies whether this community string allows access via IPv4 or IPv6.
Restrict access to specific hosts by specifying the source for SNMP requests here. The following formats
are recognized:
Hostname – myserver.mycompany.com
IPv4 Address – 192.168.50.1
IPv4 Subnet (address/mask) – 192.168.50.1/255.255.255.0
IPv4 Subnet (address/prefix length) – 192.168.50.1/24
For IPv6 access, use the equivalent formats.
Specifies the security name to add to a group as part of the SNMP view-based access control system, like
an SNMPv3 user.
Description
Specifies a name for the SNMP group.
Group names consist of 1–32 alphanumeric characters, and must begin with a letter.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
197