Network Critical SmartNA-X User Manual page 93

C L I R
OMMAND INE NTERFACE EFERENCE
S IP 4
ET V GATEWAY
Use the set ipv4 gateway command to configure the IPv4 network gateway address. The new configuration is not
implemented until you log out (exit) from the CLI. The CLI will not allow you to set gateway and IPv4 address to
an invalid combination. If you are changing both at the same time, you should use the set ipv4 static command
with the gateway option specified, rather than issuing two separate commands to change IPv4 address and
gateway.
Command form set IPv4 gateway IPv4-addr
IPv4-addr
Example Configure gateway address 192.168.0.254:
CONTROLLER>set ipv4 gateway 192.168.0.254
CONTROLLER>show ipv4
Addressing Mode : static
Address: 192.168.0.122
Netmask: 255.255.255.0
Gateway: 192.168.0.254
DNS Server: 192.168.0.5
|
Specifies the network gateway IPv4 address.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
88