Network Critical SmartNA-X User Manual page 92

C L I R
OMMAND INE NTERFACE EFERENCE
S IP 4
ET V STATIC
Use the set IPv4 static command to configure a static IPv4 network address, network mask, and optionally the
gateway address for SmartNA-X. The new configuration is not implemented until you log out (exit) from the CLI.
Command form set IPv4 static <static-addr> <mask> [gateway <IPv4-gateway>]
static-addr
mask
gateway <IPv4-gateway>
Example Configure static network settings as follows:
Address: 192.168.0.122
Subnet mask: 255.255.255.0
Gateway: 192.168.0.254
CONTROLLER>set ipv4 static 192.168.0.122 255.255.255.0 gateway 192.168.0.254
Network settings will take effect when you exit CLI.
exit to enable new network settings
CONTROLLER>exit
Exiting CLI
exit to enable new network settings
Applying new IPv4 network settings
Addressing Mode : static
Address: 192.168.0.122
Netmask: 255.255.255.0
Gateway: 192.168.0.254
Connection to 192.168.0.122 closed.
admin@example.com:~$
|
Specifies the network interface IPv4 address, in dotted-decimal format (a.b.c.d).
Default value: 192.168.254.100.
Specifies the routing prefix of the network address, also known as the network
mask (netmask).
(Optional) Specifies the network gateway IPv4 address.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
87