Et Authentication - Network Critical SmartNA-X User Manual

C L I R
OMMAND INE NTERFACE EFERENCE
S

ET AUTHENTICATION

Use the set authentication command to define the authentication method used to verify user login credentials. By
default, user accounts are authenticated locally, but you can use an authentication server to authenticate users by
choosing either RADIUS or TACACS+, as required by your authentication server. User accounts must be
administered on the authentication server, not locally, once RADIUS/TACACS authentication is enabled. Use the
create radius authserver or create tacacs authserver commands to specify the address of your authentication
server.
Command form set authentication {
{
Local
locrad
Examples • Enable RADIUS authentication:
CONTROLLER>set authentication radius
Change accepted
• Enable TACACS+ authentication:
CONTROLLER>set authentication tacacs
Change accepted
• Enable local authentication:
CONTROLLER>set authentication local
Change accepted
|
| |
Local RADIUS TACACS | locrad
| | The following authentication methods are supported:
RADIUS TACACS
| }
loctac
• – authenticates users locally (this is the default).
Local
•
RADIUS
authentication server
•
TACACS –
authentication server
•
locrad –
while setting up a RADIUS server to ensure that the system administrator is not
locked out. Once RADIUS is working, authentication should be changed to
RADIUS
• – allows both local and TACACS+ users to log in. This is intended to be
loctac
used while setting up a TACACS+ server to ensure that the system administrator is
not locked out. Once TACACS+ is working, authentication should be changed to
TACACS
S NA™ 10G N
MART
| }
loctac
– authenticates users remotely via the configured RADIUS
authenticates users remotely via the configured TACACS+
allows both local and RADIUS users to log in. This is intended to be used
.
.
DRAFT
A (S NA-X)
ETWORK CCESS MART
103