Et Port Lock - Network Critical SmartNA-X User Manual

C L I R
OMMAND INE NTERFACE EFERENCE
S

ET PORT LOCK

Use the port set port lock command to configure port locking of the currently selected TAP module. Locking a
port will prevent access to unauthorized users. This command is also used to unlock a port that has been auto-
locked.
Command form set port port-id lock {
port-id
|
on off
Examples • Enable port lock for port 4C:
SLOT4>set port C lock on
SLOT4>show port C
speed
duplex
mdi
mastering
tap
autolock
lock
usage
port type
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
• Disable port lock for port 4D:
SLOT4>set port D lock off
SLOT4>show port D
speed
duplex
mdi
mastering
tap
autolock
lock
usage
port type
PORT DOWN
traffic threshold low : 0
traffic threshold high: 100
|
| }
on off
Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
Sets the port lock to on or off. Off is the default setting for all ports.
: set 1G
: set auto actual full
: set mdi-x
: set preferslave
: off
: on
: on
: undefined
: Registered Jack 45 (RJ45)
: set auto
: set auto actual full
: set mdi
: set preferslave
: off
: off
: off
: undefined
: Registered Jack 45 (RJ45)
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
128