Network Critical SmartNA-X User Manual page 173

C L I R
OMMAND INE NTERFACE EFERENCE
SNMP
SHOW COMMUNITY
Use the snmp show community command to display SNMP community information.
SNMP SNMPv1, SNMPv2c
Command form snmp show community
Example Show community information:
CONTROLLER>snmp show community
Community number 0
IP protocol version : ipv6
comString : priSystem6
Community Type : rw
oid : ncSystemMIB
source : fec0:2:0:1111:0:5efe:836b:8101
Community number 1
IP protocol version : ipv4
comString : priRack
Community Type : rw
oid : .1.3.6.1.4.1.31645.2.2.1
source : 192.168.0.104
Community number 15
IP protocol version : ipv4
comString : privcomm
Community Type : rw
oid :
source :
...
SNMP View-based Access Control Module (VACM) commands
VACM
Control subsystem of an SNMP engine has the responsibility for checking whether a specific type of access (read,
write, notify) to a particular object (MIB instance) is allowed.
Elements of the View-based Access Control Module:
• Groups – defines the access rights to objects afforded to all security names which belong to that group. A group is
identified by a group name. The combination of a security model (SNMPv1/v2c or USM) and a security name
maps to at most one group.
• Security levels – identifies the level of security that will be assumed when checking for access rights to an object.
Different access rights for members of a group can be defined for different levels of security, namely
noAuthNoPriv, authNoPriv, and authPriv (see
• Security names – defines the principals (users) on whose behalf access is requested.
• Security models – defines the security model under which access is requested (USM, SNMPv1 or SNMPv2c).
|
(RFC 2575) is designed for inter-working of multiple versions of SNMP (v1, v2c and v3). The Access
S NA™ 10G N
MART
Table 9-1 on page 59).
DRAFT
A (S NA-X)
ETWORK CCESS MART
168