Network Critical SmartNA-X User Manual page 94

C L I R
OMMAND INE NTERFACE EFERENCE
S IP 4 DNS
ET V
Use the set IPv4 dns command to configure a DNS server. The DNS protocol controls the Domain Name System
(DNS), a distributed database with which you can map host names to IP addresses. When you configure DNS for
SmartNA-X, you can substitute the host name for the IP address with commands that take an address.
There is no IPv6 equivalent of this command.
Command form set IPv4 dns IPv4-addr
IPv4-addr
Example Configure DNS server 192.168.0.5:
CONTROLLER>set ipv4 dns 192.168.0.5
CONTROLLER>show ipv4
Addressing Mode : static
Address: 192.168.0.122
Netmask: 255.255.255.0
Gateway: 192.168.0.254
DNS Server: 192.168.0.5
CONTROLLER>exit
Exiting CLI
Connection to 192.168.0.122 closed.
admin@example.com:~$
|
Specifies the network address of the DNS server. Default value: None.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
89