Network Critical SmartNA-X User Manual page 120

C L I R
OMMAND INE NTERFACE EFERENCE
S /S
ET HOW TEMPERATUREHIGH
Use the set temperaturehigh command to set the TAP module temperature threshold for SNMP. An SNMP
notification will be sent if SNMP health notification is enabled (with the snmp enable notify health command)
and the temperature exceeds the value set here.
Use the show temperaturehigh command to display the current temperature threshold value.
Command form set temperaturehigh value
show temperaturehigh
value
Example Set a high temperature threshold of 80C for the TAP module in slot 4:
SLOT4>set temperaturehigh 80
SLOT4>show status
Card Type: MODULE_RJ_RJ
Model: 5511
Serial Number: 3400270
Firmware Version: r594
Firmware Built: Wed 08 Aug 2012 14:20:28
Hardware Revision: 1.20
Temperature: 42
Up Time: 1 days 3 hours 40 mins 53 secs
Temperature High Threshold: 80
|
Specifies a value for the high temperature threshold.
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
115