Adding A Member Or Security Name To A Group - Network Critical SmartNA-X User Manual

U SNMP | C SNMP
SING ONFIGURING
• Privacy – (Optional) You may specify whether encryption is to be used, and if so whether to use DES or
AES. If encryption is in use, you must also specify a passphrase. Privacy phrases must be 8–64 ASCII
characters (control characters are allowed) with no spaces. For users already set up on the device, either enter
a new passphrase if you wish to make a change or leave this field blank to keep the existing passphrase.
Click Add user/Save changes to finish setting up the user.
6.
Click Review/apply and review the changes you have made, and then click Apply to implement your changes.
7.
Using the CLI to configure SNMPv3 users
In the CLI, use the snmp create user username command to configure SNMPv3 users. For example, to configure
an SNMPv3 user that has MD5 authentication and DES privacy, enter the following commands:
CONTROLLER>snmp create user user3 md5 myauthphrase des myprivhrase
CONTROLLER>snmp apply
See page 172

Adding a member or security name to a group

SNMPv3 groups allow you to combine users into groups of different authorization and access privileges. Users
belonging to a particular SNMP group inherit all of these attributes defined by the group, including access policies
to SNMP objects that defines which objects can be accessed for reading, writing, and creating, the list of
notifications its users can receive, as well as the security model and security level for its users.
Using the web UI to add members or security names to a group
Log in to SmartNA-X as Administrator.
1.
Click on the chassis and select the SNMP tab.
2.
Under "View-based access control", click Configure groups. The "SNMP Groups" window appears.
3.
Click Add new group to set up a new group, or click
4.
Member" window appears.
Select group settings from the following fields:
5.
• Group name – Specify a name for the group. Names consist of 1–32 alphanumeric characters, and must
begin with a letter.
• Member – Specify the member you are adding to the group (you can only add one user at a time to a group).
The member may be an existing local SNMP user, or a security name assigned to an existing VACM-enabled
SNMP community. The membership will apply only when the specified security model is used for a request.
The same member may belong to different groups with different security models.
• Security model– Specify the group security model, either SNMPv1, SNMPv2c, or SNMPv3 USM.
Click Add group/Save changes to finish setting up the group.
6.
Click Review/apply and review the changes you have made, and then click Apply to implement your changes.
7.
for information on the snmp create user command.
S NA™ 10G N
MART
to edit an existing group. The "Add/Edit Group
DRAFT
A (S NA-X)
ETWORK CCESS MART
66