Et Port Trafficlow - Network Critical SmartNA-X User Manual

C L I R
OMMAND INE NTERFACE EFERENCE
S

ET PORT TRAFFICLOW

Use the port set port trafficlow command to set the low traffic thresholds used by SNMP to trigger a health
notification.
Command form set port port-id trafficlow {0...100}
port-id
Example Set a traffic low threshold of 10% for port 4C:
SLOT4>set port C trafficlow 10
SLOT4>show port C
speed
duplex
mdi
mastering
tap
autolock
lock
usage
port type
PORT DOWN
traffic threshold low : 10
traffic threshold high: 100
|
Specifies the port to set. Front ports are labelled A to D, left to right, and rear ports
are labelled A and B. Only one port can be set at a time.
: set 1G
: set auto actual full
: set mdi-x
: set preferslave
: off
: on
: off
: undefined
: Registered Jack 45 (RJ45)
S NA™ 10G N
MART
DRAFT
A (S NA-X)
ETWORK CCESS MART
131