AudioCodes Mediant 800B User Manual page 951

User's Manual
Parameter
EMS: Use EP Number As
Calling Number Tel to IP
CLI: epn-as-cpn-tel2ip
[UseEPNumAsCallingNumTel
2IP]
Web: Use EndPoint Number
As Calling Number IP2Tel
EMS: Use EP Number As
Calling Number IP to Tel
CLI: epn-as-cpn-ip2tel
[UseEPNumAsCallingNumIP2
Tel]
Web: Tel2IP Default Redirect
Reason
CLI: tel-to-ip-dflt-redir-rsn
[Tel2IPDefaultRedirectReason
]
Web: Redirect Number SIP to
TEL
EMS: Set IP To Tel Redirect
Screening Indicator
CLI: redir-nb-si-2tel
[SetIp2TelRedirectScreeningI
nd]
Web: Set IP-to-TEL Redirect
Reason
CLI: ip2tel-redir-reason
Version 6.8
in the Q.931 Setup message, for Tel-to-IP calls.

[0] Disable (default)

[1] Enable
For example, if the incoming calling party number in the Q.931 Setup
message is "12345" and the B-channel number is 17, then the
outgoing INVITE From header is set to "17" instead of "12345".
Note: When enabled, this feature is applied before routing and
manipulation on the source number.
Enables the use of the B-channel number as the calling party
number (sent in the Q.931 Setup message) instead of the number
received in the From header of the INVITE, for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
For example, if the incoming INVITE From header contains "12345"
and the destined B-channel number is 17, then the outgoing calling
party number in the Q.931 Setup message is set to "17" instead of
"12345".
Note: When enabled, this feature is applied after routing and
manipulation on the source number (i.e., just before sending to the
Tel side).
Determines the default redirect reason for Tel-to-IP calls when no
redirect reason (or "unknown") exists in the received Q931 ISDN
Setup message. The device includes this default redirect reason in
the SIP History-Info header of the outgoing INVITE.
If a redirect reason exists in the received Setup message, this
parameter is ignored and the device sends the INVITE message with
the reason according to the received Setup message. If this
parameter is not configured (-1), the outgoing INVITE is sent with the
redirect reason as received in the Setup message (if none or
"unknown" reason, then without a reason).

[-1] Not Configured = (Default) Received redirect reason is not
changed

[1] Busy = Call forwarding busy

[2] No Reply = Call forwarding no reply

[9] DTE Out of Order = Call forwarding DTE out of order

[10] Deflection = Call deflection

[15] Systematic/Unconditional = Call forward unconditional
Determines the value of the Redirect Number screening indicator in
ISDN Setup messages.

[-1] Not Configured (default)

[0] User Provided

[1] User Passed

[2] User Failed

[3] Network Provided
Note: This parameter is applicable only to digital PSTN interfaces
(ISDN).
Defines the redirect reason for IP-to-Tel calls. If redirect (diversion)
information is received from the IP, the redirect reason is set to the
value of this parameter before the device sends it on to the Tel.
951
56. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC