Configuring Radius Authentication - AudioCodes Mediant 800B User Manual

User's Manual

15.3.2 Configuring RADIUS Authentication

The following procedure describes how to configure the RADIUS feature. For a detailed
description of the RADIUS parameters, see 'RADIUS Parameters' on page 776.

To configure RADIUS:
1. Open the Authentication Settings page (Configuration tab > System menu >
Management > Authentication Settings).
Figure 15-8: Authentication Settings Page - RADIUS Configuration
2. Set the 'Enable RADIUS Access Control' parameter to Enable to enable the RADIUS
application.
3. Set the 'Use RADIUS for Web/Telnet Login' parameter to Enable to enable RADIUS
authentication for Web and Telnet login.
4. Define the RADIUS server:
a. In the 'RADIUS Authentication Server IP Address' field, enter the RADIUS
server's IP address.
b. In the 'RADIUS Authentication Server Port' field, enter the RADIUS server's port
number.
c. In the 'RADIUS Shared Secret' field, enter the shared secret used to authenticate
the device to the RADIUS server.
5. In the 'RADIUS VSA Vendor ID' field, enter the same vendor ID number as set on the
RADIUS server.
6. When implementing Web user access levels, do one of the following:
•
If the RADIUS server response includes the access level attribute: In the
'RADIUS VSA Access Level Attribute' field, enter the code that indicates the
access level attribute in the VSA section of the received RADIUS packet. For
defining the RADIUS server with access levels, see 'Setting Up a Third-Party
RADIUS Server' on page 200.
•
If the RADIUS server response does not include the access level attribute:
In the 'Default Access Level' field, enter the default access level that is applied to
all users authenticated by the RADIUS server.
Version 6.8 201 Mediant 800B Gateway and E-SBC
15. Services