AudioCodes Mediant 800B User Manual page 273

User's Manual
Parameter
Username
CLI: username
[IPGroup_Username]
Password
CLI: password
IPGroup_Password]
Version 6.8
routing the call. For example, if set to To, the URI in the To header of
the incoming INVITE is used as a matching characteristic for
classifying the call to an IP Group in the Classification table. Once
classified, the device uses the URI in the To header as the destination.

[-1] Not Configured (default)

[0] From

[1] To

[2] Request-URI

[3] P-Asserted - First Header

[4] P-Asserted - Second Header

[5] P-Preferred

[6] Route

[7] Diversion

[8] P-Associated-URI

[9] P-Called-Party-ID

[10] Contact

[11] Referred-by
Notes:

The parameter is applicable only when classification is done
according to the Classification table.

If the configured SIP header does not exist in the incoming INVITE
message, the classification of the message to a source IP Group
fails.

If the device receives an INVITE as a result of a REFER request or
a 3xx response, the incoming INVITE is routed according to the
Request-URI. The device identifies such INVITEs according to a
specific prefix in the Request-URI header, configured by the
SBCXferPrefix parameter. Therefore, in this scenario, the device
ignores this parameter setting.
Defines the shared username for authenticating the IP Group, when
the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
username is defined.
Notes:

This parameter is applicable only to Server-type IP Groups and
when the 'Authentication Mode' parameter is set to SBC as Server
(i.e., authentication of servers).

To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Defines the shared password for authenticating the IP Group, when
the device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
password is defined.
Notes:

This parameter is applicable only to Server-type IP Groups and
when the 'Authentication Mode' parameter is set to SBC as Server
(i.e., authentication of servers).

To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
273
Description
Mediant 800B Gateway and E-SBC
17. Control Network