AudioCodes Mediant 800B User Manual page 283

User's Manual
Parameter
Served IP Group
CLI: served-ip-group
[Account_ServedIPGroup]
Serving IP Group
CLI: serving-ip-group
[Account_ServingIPGroup]
User Name
CLI: user-name
[Account_Username]
Password
CLI: password
[Account_Password]
Host Name
CLI: host-name
[Account_HostName]
Register
CLI: register
[Account_Register]
Contact User
CLI: contact-user
[Account_ContactUser]
Version 6.8
Defines the IP Group (e.g., IP-PBX) that you want to register and/or
authenticate.
Note: This parameter is applicable only to the SBC and Gateway's
IP-to-IP application.
Defines the IP Group to where the device sends the SIP REGISTER
requests (if enabled) for registration and authentication.

For Tel-to-IP calls, the serving IP Group is the destination IP
Group configured in the Trunk Group Settings table or Outbound
IP Routing table (see Configuring the Outbound IP Routing Table
on page 383).

For IP-to-Tel calls, the serving IP Group is the 'Source IP Group
ID' configured in the Inbound IP Routing table (see Configuring the
Inbound IP Routing Table on page 392).
Defines the digest MD5 Authentication username.
The valid value is a string of up to 50 characters.
Defines the digest MD5 Authentication password.
The valid value is a string of up to 50 characters.
Defines the Address of Record (AOR) host name. The host name
appears in SIP REGISTER From/To headers as
ContactUser@HostName. For a successful registration, the host
name is also included in the URI of the INVITE From header.
The valid value is a string of up to 49 characters.
Note: If this parameter is not configured or if registration fails, the 'SIP
Group Name' parameter value configured in the IP Group table is
used instead.
Enables registration.

[0] No (Default)

[1] Regular = Regular registration process. For more information,
see ''Regular Registration Mode'' on page 284.

[2] GIN = Registration for legacy PBXs, using Global Identification
Number (GIN). For more information, see ''Single Registration for
Multiple Phone Numbers using GIN'' on page 284.
Notes:

(Gateway application) To enable registration, you also need to set
the 'Registration Mode' parameter to Per Account in the Hunt
Group Settings table (see Configuring Hunt Group Settings on
page 353).

The Trunk Group account registration is not affected by the
IsRegisterNeeded parameter.
Defines the AOR username. This appears in REGISTER From/To
headers as ContactUser@HostName, and in INVITE/200 OK Contact
headers as ContactUser@<device's IP address>.
Notes:

If this parameter is not configured, the 'Contact User' parameter in
the IP Group table is used instead.

If registration fails, the user part in the INVITE Contact header
contains the source party number.
283
Description
Mediant 800B Gateway and E-SBC
18. SIP Definitions