AudioCodes Mediant 800B User Manual page 372

Parameter
CLI: dst-host-prefix
[_DestHost]
Operation (Action)
Web: Stripped Digits From
Left
EMS: Remove From Left
CLI: remove-from-left
[_RemoveFromLeft]
Web: Stripped Digits From
Right
EMS: Remove From Right
CLI: remove-from-right
[_RemoveFromRight]
Web/EMS: Number of Digits
to Leave
CLI: num-of-digits-to-leave
[_LeaveFromRight]
Web/EMS: Prefix to Add
CLI: prefix-to-add
[_Prefix2Add]
Web/EMS: Suffix to Add
CLI: suffix-to-add
[_Suffix2Add]
Web: Presentation
EMS: Is Presentation
Restricted
CLI: is-presentation-
restricted
[_IsPresentationRestricted]
Web: TON
EMS: Number Type
CLI: ton
[_NumberType]
User's Manual
incoming SIP INVITE message.
The default value is the asterisk (*) symbol (i.e., any prefix).
Note: This parameter is applicable only to the Redirect Number IP-to-
Tel table.
Defines the number of digits to remove from the left of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 1234.
Defines the number of digits to remove from the right of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 5551.
Defines the number of digits that you want to retain from the right of
the redirect number.
Defines the number or string that you want added to the front of the
redirect number. For example, if you enter 9 and the redirect number
is 1234, the new number is 91234.
Defines the number or string that you want added to the end of the
redirect number. For example, if you enter 00 and the redirect number
is 1234, the new number is 123400.
Enables caller ID.

Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 463).

[0] Allowed = Sends Caller ID information when a call is made
using these destination / source prefixes.

[1] Restricted = Restricts Caller ID information for these prefixes.
Note: If this parameter is set to Restricted and the 'AssertedIdMode'
parameter is set to Add P-Asserted-Identity, the From header in the
INVITE message includes the following:
From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id'
header.
Defines the Type of Number (TON).
The default is Not Configured [-1].

If NPI is set to Unknown, you can set TON to Unknown [0].

If NPI is set to Private, you can set TON to Unknown [0],
International [1], National [2], Network Specific [3] or Subscriber
[4].

If NPI is set to E.164 Public, you can set TON to Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4]
or Abbreviated [6].
For more information on available NPI/TON values, see Numbering
Plans and Type of Number on page 382.
372
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286