AudioCodes Mediant 800B User Manual page 928

Parameter
CLI: play-rbt-2ip
[PlayRBTone2IP]
Web: Play Local RBT on ISDN
Transfer
EMS: Play RBT On ISDN
Transfer
CLI: play-l-rbt-isdn-trsfr
[PlayRBTOnISDNTransfer]
Web: MFC R2 Category
EMS: R2 Category
CLI: mfcr2-category
[R2Category]
Tone Index Table
Web: Tone Index Table
EMS: Analog Gateway
Provisioning > Tone Index
CLI: configure voip > gw
analoggw tone-index
[ToneIndex]
User's Manual
(IpProfile_PlayRBTone2IP). For a detailed description of this
parameter and for configuring this functionality in the IP Profile
table, see ''Configuring IP Profiles'' on page 304.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Determines whether the device plays a local ringback tone for
ISDN's Two B Channel Transfer (TBCT), Release Line Trunk
(RLT), or Explicit Call Transfer (ECT) call transfers to the originator
when the second leg receives an ISDN Alerting or Progress
message.

[0] Don't Play (default)

[1] Play
Notes:

For Blind transfer, the local ringback tone is played to first call
PSTN party when the second leg receives the ISDN Alerting or
Progress message.

For Consulted transfer, the local ringback tone is played when
the second leg receives ISDN Alerting or Progress message if
the Progress message is received after a SIP REFER.

This parameter is applicable only if the parameter
SendISDNTransferOnConnect is set to 1.
Defines the tone for MFC R2 calling party category (CPC). The
parameter provides information on the calling party such as
National or International call, Operator or Subscriber and
Subscriber priority.
The value range is 1 to 15 (defining one of the MFC R2 tones). The
default is 1.
This table parameter configures the Tone Index table, which allows
you to define distinctive ringing and call waiting tones per FXS
endpoint (or for a range of FXS endpoints).
The format of the ini file table parameter is as follows:
[ToneIndex]
FORMAT ToneIndex_Index = ToneIndex_FXSPort_First,
ToneIndex_FXSPort_Last, ToneIndex_SourcePrefix,
ToneIndex_DestinationPrefix, ToneIndex_PriorityIndex;
[\ToneIndex]
For example, the configuration below plays the tone Index #3 to
FXS ports 1 and 2 if the source number prefix of the received call is
20.
ToneIndex 1 = 1, 2, 20*, , 3;
For a detailed description of this table, see Configuring FXS
Distinctive Ringing and Call Waiting Tones per Source/Destination
Number.
928
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286