AudioCodes Mediant 800B User Manual page 941

User's Manual
Parameter
Web/EMS: Use Display Name as
Source Number
CLI: disp-name-as-src-nb
[UseDisplayNameAsSourceNumber]
Web: ENUM Resolution
CLI: enum-service-domain
[EnumService]
Web: Use Routing Table for Host
Names and Profiles
EMS: Use Routing Table For Host
Names
CLI: rte-tbl-4-host-names
[AlwaysUseRouteTable]
Web/EMS: Tel to IP Routing Mode
CLI: tel2ip-rte-mode
Version 6.8
56. Configuration Parameters Reference
the Tel Display Name is used as the IP Display Name. If
no Display Name is received from the Tel side, the Tel
Source Number is used as the IP Source Number and
also as the IP Display Name.

[2] Overwrite = The Tel Source Number is used as the IP
Source Number and also as the IP Display Name (even if
the received Tel Display Name is not empty).

[3] Original = Similar to option [2], except that the
operation is done before regular calling number
manipulation.
Determines the use of Source Number and Display Name
for IP-to-Tel calls.

[0] No = (Default) If IP Display Name is received, the IP
Source Number is used as the Tel Source Number and
the IP Display Name is used as the Tel Display Name. If
no Display Name is received from IP, the Tel Display
Name remains empty.

[1] Yes = If an IP Display Name is received, it is used as
the Tel Source Number and also as the Tel Display
Name, and Presentation is set to Allowed (0). If no
Display Name is received from IP, the IP Source Number
is used as the Tel Source Number and Presentation is
set to Restricted (1).
For example: When 'From: 100
<sip:200@201.202.203.204>' is received, the outgoing
Source Number and Display Name are set to '100' and the
Presentation is set to Allowed (0).
When 'From: <sip:100@101.102.103.104>' is received, the
outgoing Source Number is set to '100' and the Presentation
is set to Restricted (1).
Defines the ENUM service for translating telephone numbers
to IP addresses or domain names (FQDN), for example,
e164.arpa, e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
Note: For the Gateway / IP-to-IP application, ENUM-based
routing is configured in the Outbound IP Routing table using
the "ENUM" string value as the destination address to
denote this parameter's value.
Determines whether to use the device's routing table to
obtain the URI host name and optionally, an IP profile (per
call) even if a Proxy server is used.

[0] Disable = (Default) Don't use internal routing table.

[1] Enable = Use the Outbound IP Routing table.
Notes:

This parameter appears only if the 'Use Default Proxy'
parameter is enabled.

The domain name is used instead of a Proxy name or IP
address in the INVITE SIP URI.
For a description of this parameter, see ''Configuring
Outbound IP Routing Table'' on page 383.
941
Description
Mediant 800B Gateway and E-SBC