AudioCodes Mediant 800B User Manual page 186

Parameter
Web: NetBIOS Node Type
CLI: netbios-node-type
[DhcpServer_NetbiosNodeType]
Web: NTP Server 1
CLI: ntp-server-1
[DhcpServer_NTPServer1]
Web: NTP Server 2
CLI: ntp-server-2
[DhcpServer_NTPServer2]
Web: Time Offset
CLI: time-offset
[DhcpServer_TimeOffset]
Web: TFTP Server
CLI: tftp-server-name
[DhcpServer_TftpServer]
Web: Boot file name
CLI: boot-file-name
[DhcpServer_BootFileName]
Web: Expand Boot-file Name
CLI: expand-boot-file-name
[DhcpServer_ExpandBootfileName]
User's Manual
Defines the node type of the NetBIOS WINS server for a
Microsoft DHCP client. The value is sent in DHCP Option 46
(NetBIOS Node Type).

[0] Broadcast (default)

[1] peer-to-peer

[4] Mixed

[8] Hybrid
Defines the IP address (IPv4) of the primary NTP server that
the DHCP server assigns to the DHCP client. The value is
sent in DHCP Option 42 (Network Time Protocol Server).
The default value is 0.0.0.0.
Defines the IP address (IPv4) of the secondary NTP server
that the DHCP server assigns to the DHCP client. The value
is sent in DHCP Option 42 (Network Time Protocol Server).
The default value is 0.0.0.0.
Defines the Greenwich Mean Time (GMT) offset (in seconds)
that the DHCP server assigns to the DHCP client. The value
is sent in DHCP Option 2 (Time Offset).
The valid range is -43200 to 43200. The default is 0.
Defines the IP address or name of the TFTP server that the
DHCP server assigns to the DHCP client. The TFTP server
typically stores the boot file image, defined in the 'Boot file
name' parameter (see below). The value is sent in DHCP
Option 66 (TFTP Server Name).
The valid value is a string of up to 80 characters. By default,
no value is defined.
Defines the name of the boot file image for the DHCP client.
The boot file stores the boot image for the client. The boot
image is typically the operating system the client uses to load
(downloaded from a boot server). The value is sent in DHCP
Option 67 (Bootfile Name). To define the server storing the
file, use the 'TFTP Server' parameter (see above).
The valid value is a string of up to 256 characters. By default,
no value is defined.
The name can also include the following case-sensitive
placeholder strings that are replaced with actual values if the
'Expand Boot-file Name' parameter is set to Yes:

<MAC>: Replaced by the MAC address of the client (e.g.,
boot_<MAC>.ini). The MAC address is obtained in the
client's DHCP request.

<IP>: Replaced by the IP address assigned by the DHCP
server to the client.
Enables the use of the placeholders in the boot file name,
defined in the 'Boot file name' parameter.

[0] No

[1] Yes (default)
186
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286