Route Name; Cli: Route-Name; Web: Dest. Host Prefix; Cli: Dst-Phone-Prefix - AudioCodes Mediant 800B User Manual


To configure IP-to-Tel or inbound IP routing rules:
1. Open the Inbound IP Routing Table page (Configuration tab > VoIP menu > GW and
IP to IP > Routing > IP to Trunk Group Routing).
The previous figure displays the following configured routing rules:
•
Rule 1: If the incoming IP call destination phone prefix is between 10 and 19, the
call is assigned settings configured for IP Profile ID 2 and routed to Trunk Group
ID 1.
•
Rule 2: If the incoming IP call destination phone prefix is between 501 and 502
and source phone prefix is 101, the call is assigned settings configured for IP
Profile ID 1 and routed to Trunk Group ID 2.
•
Rule 3: If the incoming IP call has a From URI host prefix as domain.com, the call
is routed to Trunk Group ID 3.
•
Rule 4: If the incoming IP call has IP address 10.13.64.5 in the INVITE's Contact
header, the call is identified as an IP-to-IP call and assigned to Source IP Group
4. This call is routed according to the outbound IP routing rules for this Source IP
Group configured in the Outbound IP Routing table.
2. Configure a routing rule according to the parameters described in the table below.
3. Click Submit.
Table 24-3: IP-to-Tel or Inbound IP Routing Table Parameter Description
Parameter
IP to Tel Routing Mode
CLI: configure voip/gw routing
general-setting/ip2tel-rte-mode
[RouteModeIP2Tel]
Index
[PstnPrefix_Index]

Route Name

CLI: route-name

[PstnPrefix_RouteName]
Matching Characteristics

Web: Dest. Host Prefix

CLI: dst-phone-prefix

[PstnPrefix_DestPrefix]
User's Manual
Figure 24-3: Inbound IP Routing Table
Determines whether to route the incoming IP call before or after
manipulation of destination number, configured in ''Configuring
Source/Destination Number Manipulation'' on page 359.

[0] Route calls before manipulation = (Default) Incoming IP
calls are routed before number manipulation.

[1] Route calls after manipulation = Incoming IP calls are
routed after number manipulation.
Defines an index number for the new table record.

Defines an arbitrary name to easily identify the routing rule.

The valid value is a string of up to 20 characters. By default, no
value is defined.
Defines the Request-URI host name prefix of the incoming SIP
INVITE message.
By default, no value is defined (i.e., not used in routing rule). To
denote any prefix, use the asterisk (*) wildcard.
394
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286