AudioCodes Mediant 800B User Manual page 923

User's Manual
Parameter
Web: FXO AutoDial Play
BusyTone
EMS: Auto Dial Play Busy Tone
CLI: fxo-autodial-play-bsytn
[FXOAutoDialPlayBusyTone]
Web: Hotline Dial Tone
Duration
EMS: Hot Line Tone Duration
CLI: hotline-dt-dur
[HotLineToneDuration]
Web/EMS: Reorder Tone
Duration [sec]
CLI: reorder-tone-duration
[TimeForReorderTone]
Web: Time Before Reorder
Tone [sec]
EMS: Time For Reorder Tone
CLI: time-b4-reordr-tn
[TimeBeforeReorderTone]
Web: Cut Through Reorder
Tone Duration [sec]
CLI: cut-thru-reord-dur
Version 6.8
longer than 16 seconds, you must increase the value of the
parameter TimeForDialTone accordingly.

The MWI tone takes precedence over the call forwarding
reminder tone. For more information on MWI, see Message
Waiting Indication on page 421.
Determines whether the device plays a busy / reorder tone to the
PSTN side if a Tel-to-IP call is rejected by a SIP error response
(4xx, 5xx or 6xx). If a SIP error response is received, the device
seizes the line (off-hook), and then plays a busy / reorder tone to
the PSTN side (for the duration defined by the parameter
TimeForReorderTone). After playing the tone, the line is released
(on-hook).

[0] = Disable (default)

[1] = Enable
Note: This parameter is applicable only to FXO interfaces.
Defines the duration (in seconds) of the hotline dial tone. If no digits
are received during this duration, the device initiates a call to a
user-defined number (configured in the Automatic Dialing table -
TargetOfChannel - see Configuring Automatic Dialing on page
462).
The valid range is 0 to 60. The default is 16.
Notes:

This parameter is applicable to FXS and FXO interfaces.

You can define the Hotline duration per FXS/FXO port using the
Automatic Dialing table.
For analog interfaces: Defines the duration (in seconds) that the
device plays a busy or reorder tone before releasing the line.
Typically, after playing the busy or reorder tone for this duration,
the device starts playing an offhook warning tone.
For digital interfaces: Defines the duration (in seconds) that the
CAS device plays a busy or reorder tone before releasing the line.
The valid range is 0 to 254. The default is 0 seconds for analog
interfaces and 10 seconds for digital interfaces. Note that the Web
interface denotes the default value (for analog and digital
interfaces) as a string value of "255".
Notes:

The selected busy or reorder tone is according to the SIP
release cause code received from IP.

This parameter is also applicable for ISDN when the
PlayBusyTone2ISDN parameter is set to 2.

This parameter can also be configured for a Tel Profile (in the
Tel Profile table).
Defines the delay interval (in seconds) from when the device
receives a SIP BYE message (i.e., remote party terminates call)
until the device starts playing a reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Defines the duration (in seconds) of the reorder tone played to the
PSTN side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call is
923
56. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC