Sip Test Call Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Web: Delay After Reset [sec]
CLI: delay-after-reset
[GWAppDelayTime]
[EnableAutoRAITransmitBER] Enables the device to send a remote alarm indication (RAI) when
Web: Ignore BRI LOS Alarm
CLI: ignore-bri-los-alarm
[IgnoreBRILOSAlarm]

56.3.2 SIP Test Call Parameters

The SIP Signaling Test Call parameters are described in the table below.
Parameter
Web: Test Call DTMF
String
CLI:testcall-dtmf-string
[TestCallDtmfString]
Web: Test Call ID
CLI: testcall-id
[TestCallID]
Version 6.8

FXS Port 1
FXS Port 1 connects to the POTS (Lifeline) phone as well as to the
PSTN / PBX, using a splitter cable.
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only to FXS interfaces.

To enable Lifeline upon network failure, the LAN Watchdog
feature must be activated (see the EnableLANWatchDog
parameter).

The number of supported Lifelines depends on the device's
hardware configuration. For the combined FXS/FXO
configuration, one Lifeline is available; for the 12-FXS
configuration, up to three Lifelines are available.

For information on Lifeline cabling, refer to the Installation
Manual.
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by
a DHCP server.
the bit error rate (BER) is greater than 0.001.

[0] Disable (default)

[1] Enable
Enables the device to ignore LOS alarms received from the BRI
user-side trunk and attempts to make a call (relevant for IP-to-Tel
calls).

[0] Disable

[1] Enable (default)
Table 56-20: SIP Test Call Parameters
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is
defined.
Notes:

This parameter is only for testing incoming calls destined to this
759
56. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway and E-SBC