AudioCodes Mediant 800B User Manual page 856

Parameter
EMS: Bellcore Caller ID Type One
Sub Standard
CLI: bellcore-callerid-type-one-sub-
standard
[BellcoreCallerIDTypeOneSubStan
dard]
EMS: ETSI Caller ID Type One
Sub Standard
CLI: etsi-callerid-type-one-sub-
standard
[ETSICallerIDTypeOneSubStandar
d]
Web: Asserted Identity Mode
EMS: Asserted ID Mode
CLI: asserted-identity-m
[AssertedIdMode]
Web/EMS: Use Destination As
Connected Number
[UseDestinationAsConnectedNu
mber]
User's Manual

If this parameter is set to 1 and used with distinctive ringing,
the Caller ID signal doesn't change the distinctive ringing
timing.

For this parameter to take effect, a device reset is required.
Determines the Bellcore Caller ID sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note: For this parameter to take effect, a device reset is
required.
Determines the ETSI FSK Caller ID Type 1 sub-standard (FXS
only).

[0] = (Default) ETSI between rings.

[1] = ETSI before ring DT_AS.

[2] = ETSI before ring RP_AS.

[3] = ETSI before ring LR_DT_AS.

[4] = ETSI not ring related DT_AS.

[5] = ETSI not ring related RP_AS.

[6] = ETSI not ring related LR_DT_AS.
Note: For this parameter to take effect, a device reset is
required.
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is added to the sent INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are
used to present the calling party's Caller ID, which is composed
of a Calling Number and a Calling Name (optional).

[0] Disabled = (Default) P-Asserted-Identity and P-Preferred-
Identity headers are not added.

[1] Add P-Asserted-Identity

[2] Add P-Preferred-Identity
The used header also depends on the calling Privacy (allowed
or restricted). These headers are used together with the Privacy
header. If Caller ID is restricted (i.e., P-Asserted-Identity is not
sent), the Privacy header includes the value 'id' ('Privacy: id').
Otherwise, for allowed Caller ID, 'Privacy: none' is used. If Caller
ID is restricted (received from PSTN / Tel or configured in the
device), the From header is set to
<anonymous@anonymous.invalid>.
The 200 OK response can contain the connected party CallerID
- Connected Number and Connected Name. For example, if the
call is answered by the device, the 200 OK response includes
the P-Asserted-Identity with Caller ID. The device interworks (in
some ISDN variants), the Connected Party number and name
from Q.931 Connect message to SIP 200 OK with the P-
Asserted-Identity header. In the opposite direction, if the ISDN
device receives a 200 OK with P-Asserted-Identity header, it
interworks it to the Connected party number and name in the
Q.931 Connect message, including its privacy.
Enables the device to include the Called Party Number, from
outgoing Tel calls (after number manipulation), in the SIP P-
Asserted-Identity header. The device includes the SIP P-
Asserted-Identity header in 180 Ringing and 200 OK responses
856
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286