AudioCodes Mediant 800B User Manual page 139

Analog & digital voip media gateway
Hide thumbs Also See for Mediant 800B:
Table of Contents

Advertisement

User's Manual
behind NAT and always sends the media packets to the UA using the source address
obtained from the first media packet received from the UA. In this mode, the device
does not send any packets until it receives the first packet from the UA (in order to
obtain the IP address).
To enable NAT resolution using the First Incoming Packet mechanism:
1.
Open the General Settings page (Configuration tab > VoIP menu > Media > General
Media Settings).
2.
Set the 'NAT Mode parameter to one of the following:
[0] Auto-Detect
[1] NAT Is Not Used
[2] NAT Is Used
3.
Click Submit.
12.11.2.2.2
No-Op Packets
The device's No-Op packet support can be used to verify Real-Time Transport Protocol
(RTP) and T.38 connectivity, and to keep NAT bindings and Firewall pinholes open. The
No-Op packets are available for sending in RTP and T.38 formats.
You can control the activation of No-Op packets by using the ini file parameter
NoOpEnable. If No-Op packet transmission is activated, you can control the time interval in
which No-Op packets are sent in the case of silence (i.e., no RTP or T.38 traffic). This is
done using the ini file parameter NoOpInterval. For a description of the RTP No-Op ini file
parameters, see ''Networking Parameters'' on page 747.
RTP No-Op: The RTP No-Op support complies with IETF Internet-Draft draft-wing-
avt-rtp-noop-03 ("A No-Op Payload Format for RTP"). This IETF document defines a
No-Op payload format for RTP. The draft defines the RTP payload type as dynamic.
You can control the payload type with which the No-Op packets are sent. This is
performed using the RTPNoOpPayloadType ini parameter (see ''Networking
Parameters'' on page 747). The default payload type is 120.
T.38 No-Op: T.38 No-Op packets are sent only while a T.38 session is activated. Sent
packets are a duplication of the previously sent frame (including duplication of the
sequence number).
Note:
Version 6.8
Receipt of No-Op packets is always supported.
139
Mediant 800B Gateway and E-SBC
12. Network

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents