AudioCodes Mediant 800B User Manual page 719

User's Manual
Parameter
IP Group ID
CLI: ip-group-id
[Test_Call_IPGroupID]
Destination Address
CLI: dst-address
[Test_Call_DestAddress]
Destination Transport Type
CLI: dst-transport
[Test_Call_DestTransportType]
SRD
CLI: srd
[Test_Call_SRD]
Application Type
CLI: application-type
[Test_Call_ApplicationType]
QoE Profile
CLI: qoe-profile
[Test_Call_QOEProfile]
Bandwidth Profile
CLI: bandwidth-profile
[Test_Call_BWProfile]
Authentication Tab
Note: These parameters are applicable only if the Call Party parameter is set to Caller.
Auto Register
CLI: auto-register
[Test_Call_AutoRegister]
Username
CLI: user-name
[Test_Call_UserName]
Version 6.8

For REGISTER messages, if option [1] is used, only Server-
type IP Groups can be used.
Defines the IP Group ID to which the test call is sent or from
which it is received.
Notes:

This parameter is applicable only if option [1] is configured for
the 'Route By' parameter.

This IP Group is used for incoming and outgoing calls.
Defines the destination host. This can be defined as an IP
address[:port] or DNS name[:port].
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: This parameter is applicable only if the 'Route By'
parameter is set to [2] (Dest Address).
Defines the SRD for the endpoint.
The default is SRD 0.
Note: This parameter is applicable only if the 'Route By'
parameter is set any option except [1] (IP Group).
Defines the application type for the endpoint. This, in effect,
associates the IP Group and SRD to a specific SIP interface. For
example, assume two SIP Interfaces are configured in the SIP
Interface table where one is set to "GW & IP2IP" and one to
"SBC" for the 'Application Type'. If this parameter is set ot "SBC",
the device uses the SIP Interface set to "SBC".

[0] GW & IP2IP (default)

[2] SBC
Assigns a QoE Profile to the test call. To configure QoE Profiles,
see ''Configuring Quality of Experience Profiles'' on page 242.
Assigns a Bandwidth Profile to the test call. To configure
Bandwidth Profiles, see ''Configuring Bandwidth Profiles'' on page
246.
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group ID' parameter settings (see above).

[0] Disable (default)

[1] Enable
Defines the authentication username.
By default, no username is defined.
719
54. Testing SIP Signaling Calls
Description
Mediant 800B Gateway and E-SBC