AudioCodes Mediant 800B User Manual page 788

Parameter
Web: Gateway Registration Name
EMS: Name
CLI: gw-registration-name
[GWRegistrationName]
Web/EMS: Registration Mode
CLI: authentication-mode
[AuthenticationMode]
Web: Set Out-Of-Service On
Registration Failure
EMS: Set OOS On Registration Fail
CLI: set-oos-on-reg-failure
[OOSOnRegistrationFail]
CLI: expl-un-reg
[UnregistrationMode]
User's Manual
Defines the user name that is used in the From and To
headers in SIP REGISTER messages. If no value is specified
(default) for this parameter, the UserName parameter is used
instead.
Notes:

This parameter is applicable only to the Gateway
application.

This parameter is applicable only for single registration per
device (i.e., AuthenticationMode is set to 1). When the
device registers each channel separately (i.e.,
AuthenticationMode is set to 0), the user name is set to the
channel's phone number.
Determines the device's registration and authentication
method.

[0] Per Endpoint = Registration and authentication is
performed separately for each endpoint/B-channel. This is
typically used for FXS interfaces, where each endpoint
registers (and authenticates) separately with its user name
and password.

[1] Per Gateway = (Default) Single registration and
authentication for the entire device. This is typically used for
FXO interfaces and digital modules.

[3] Per FXS = Registration and authentication for FXS
endpoints.
Note: This parameter is applicable only to the Gateway
application.
Enables setting the endpoint, trunk, or entire device (i.e., all
endpoints) to out-of-service if registration fails.

[0] Disable (default)

[1] Enable
If the registration is per endpoint (i.e., AuthenticationMode is
set to 0) or per Account (see Configuring Hunt Group Settings
on page 353) and a specific endpoint/Account registration fails
(SIP 4xx or no response), then that endpoint is set to out-of-
service until a success response is received in a subsequent
registration request. When the registration is per the entire
device (i.e., AuthenticationMode is set to 1) and registration
fails, all endpoints are set to out-of-service. If all the Accounts
of a specific Trunk Group fail registration and if the Trunk
Group comprises a complete trunk, then the entire trunk is set
to out-of-service.
Notes:

This parameter is applicable only to the Gateway
application.

The out-of-service method is configured using the
FXSOOSBehavior parameter.
Enables the device to perform explicit unregisters.

[0] Disable (default)

[1] Enable = The device sends an asterisk ("*") value in the
SIP Contact header, instructing the Registrar server to
remove all previous registration bindings. The device
removes SIP User Agent (UA) registration bindings in a
788
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286