Configuring Call Forward - AudioCodes Mediant 800B User Manual

User's Manual
27.7

Configuring Call Forward

The Call Forward table lets you configure call forwarding per FXS or FXO port, for IP-to-Tel
calls. This redirects the call, using a SIP 302 response, initially destined to a specific port,
to a different port on the device or to an IP destination.
Note:
This is done in the Supplementary Services page (Configuration tab > VoIP menu >
GW and IP to IP > DTMF and Supplementary > Supplementary Services).
The following procedure describes how to configure call forwarding per port in the Web
interface. You can also configure this using the table ini file parameter, FwdInfo or CLI
command, configure voip > gw analoggw call-forward.

To configure call forward per port:
1. Open the Call Forward Table page (Configuration tab > VoIP menu > GW and IP to
IP > Analog Gateway > Call Forward).
2. Click Add; the following dialog box appears:
3. Configure call forwarding per port according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Index
[FwdInfo_Index]
Module
[FwdInfo_Module]
Port
[FwdInfo_Port]
Port Type
[FwdInfo_PortType]
Type
CLI: type
[FwdInfo_Type]
Version 6.8
To enable call forwarding, set the 'Enable Call Forward' parameter to Enable.
Figure 27-5: Call Forward Table - Edit Record
Table 27-4: Call Forward Table Parameter Descriptions
(Read-only) Displays the index number of the table record.
(Read-only) Displays the module number on which the port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
Defines the condition upon which the call is forwarded.

[0] Deactivate = (Default) Don't forward incoming calls.
Description
465 Mediant 800B Gateway and E-SBC
27. Analog Gateway