AudioCodes Mediant 800B User Manual page 850

Parameter
Web/EMS: Enable SMDI
[SMDI]
Web/EMS: SMDI Timeout
[SMDITimeOut]
Message Waiting Indication (MWI) Parameters
Web: MWI Off Digit Pattern
EMS: MWI Off Code
CLI: mwi-off-dig-ptrn
[MWIOffCode]
Web: MWI On Digit Pattern
EMS: MWI On Code
CLI: mwi-on-dig-ptrn
[MWIOnCode]
Web: MWI Suffix Pattern
EMS: MWI Suffix Code
CLI: mwi-suffix-pattern
[MWISuffixCode]
Web: MWI Source Number
EMS: MWI Source Name
CLI: mwi-source-number
[MWISourceNumber]
CLI: mwi-subs-ipgrpid
[MWISubscribeIPGroupID]
User's Manual
Enables Simplified Message Desk Interface (SMDI) interface on
the device.

[0] Disable = (Default) Normal serial

[1] Enable (Bellcore)

[2] Ericsson MD-110

[3] NEC (ICS)
Notes:

For this parameter to take effect, a device reset is required.

When the RS-232 connection is used for SMDI messages
(Serial SMDI), it cannot be used for other applications, for
example, to access the Command Line Interface (CLI).
Defines the time (in msec) that the device waits for an SMDI Call
Status message before or after a Setup message is received. This
parameter synchronizes the SMDI and analog CAS interfaces.
If the timeout expires and only an SMDI message is received, the
SMDI message is dropped. If the timeout expires and only a Setup
message is received, the call is established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default is
2000.
Defines the digit code used by the device to notify the PBX that
there are no messages waiting for a specific extension. This code
is added as prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device to notify the PBX of
messages waiting for a specific extension. This code is added as
prefix to the dialed number.
The valid range is a 25-character string.
Defines the digit code used by the device as a suffix for 'MWI On
Digit Pattern' and 'MWI Off Digit Pattern'. This suffix is added to the
generated DTMF string after the extension number.
The valid range is a 25-character string.
Defines the calling party's phone number used in the Q.931 MWI
Setup message to PSTN. If not configured, the channel's phone
number is used as the calling number.
Defines the IP Group ID used when subscribing to an MWI server.
The 'The SIP Group Name' field value of the IP Group table is used
as the Request-URI host name in the outgoing MWI SIP
SUBSCRIBE message. The request is sent to the IP address
defined for the Proxy Set that is associated with the IP Group. The
Proxy Set's capabilities such as proxy redundancy and load
balancing are also applied to the message.
For example, if the 'SIP Group Name' field of the IP Group is set to
"company.com", the device sends the following SUBSCRIBE
message:
SUBSCRIBE sip:company.com...
Instead of:
SUBSCRIBE sip:10.33.10.10...
Note: If this parameter is not configured, the MWI SUBSCRIBE
850
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10286