AudioCodes Mediant 800B User Manual page 919

User's Manual
Parameter
od]
Web: Silence Detection Method
[FarEndDisconnectSilenceMeth
od]
[FarEndDisconnectSilenceThre
shold]
[BrokenConnectionDuringSilen
ce]
Web: Trunk Alarm Call
Disconnect Timeout
CLI: trk-alrm-call-disc-to
[TrunkAlarmCallDisconnectTimeo
ut]
Web: Disconnect Call on Busy
Tone Detection (ISDN)
EMS: Isdn Disconnect On Busy
Tone
CLI: disc-on-bsy-tone-i
[ISDNDisconnectOnBusyTone]
Web: Disconnect Call on Busy
Tone Detection
EMS: Disconnect On Detection
End Tones
CLI: disc-on-bsy-tone-c
[DisconnectOnBusyTone]
Version 6.8
seconds.
Note: For this parameter to take effect, a device reset is required.
Determines the silence detection method.

[0] None = Silence detection option is disabled.

[1] Packets Count = According to packet count.
Note: For this parameter to take effect, a device reset is required.
Defines the threshold of the packet count (in percentages) below
which is considered silence by the device.
The valid range is 1 to 100%. The default is 8%.
Notes:

This parameter is applicable only if silence is detected
according to packet count (FarEndDisconnectSilenceMethod
is set to 1).

For this parameter to take effect, a device reset is required.
Enables the generation of the BrokenConnection event during a
silence period if the channel's NoOp feature is enabled (using the
parameter NoOpEnable) and if the channel stops receiving NoOp
RTP packets.

[0] Disable (default)

[1] Enable
Defines the duration (in seconds) to wait after an E1/T1 trunk
"Red" alarm (LOS / LOF) is raised, before the device disconnects
the SIP call. If this timeout expires and the alarm is still raised, the
device sends a SIP BYE message to terminate the call. If the
alarm is cleared before this timeout expires, the call is not
terminated, but continues as normal.
The range is 1 to 3600. The default is 0 (20 for E1 and 40 for T1).
Determines whether a call is disconnected upon detection of a
busy tone (for ISDN).

[0] Disable = (Default) Do not disconnect call upon detection
of busy tone.

[1] Enable = Disconnect call upon detection of busy tone.
Notes:

This parameter is applicable only to ISDN protocols.

IP-to-ISDN calls are disconnected on detection of SIT tones
only in call alert state. If the call is in connected state, the SIT
does not disconnect the calls. Detection of busy or reorder
tones disconnects the IP-to-ISDN calls also in call connected
state.

For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the calls in any call state.
Determines whether a call is disconnected upon detection of a
busy tone.

[0] Disable = Call is not disconnected upon detection of a busy
tone.

[1] Enable = (Default) Call is released upon detection of busy
or reorder (fast busy) tone.
Notes:
919
56. Configuration Parameters Reference
Description
Mediant 800B Gateway and E-SBC