Configuring Call Forward - AudioCodes MP-11x User Manual

User's Manual
26.8

Configuring Call Forward

The Call Forwarding table allows you to configure call forwarding per port for IP-to-Tel
calls. This redirects the call (using SIP 302 response) initially destined to a specific device
Tel port, to a different device port or to an IP destination.
Notes:
•
To enable call forwarding, set the 'Enable Call Forward' parameter to Enable. This
is done in the Supplementary Services page (Configuration tab > VoIP menu >
GW and IP to IP > DTMF and Supplementary > Supplementary Services).
•
The Call Forward table can also be configured using the table ini file parameter,
FwdInfo.

To configure Call Forward per port:
1. Open the Call Forward Table page (Configuration tab > VoIP menu > GW and IP to
IP > Analog Gateway > Call Forward).
2. Configure the table as required. For descriptions of the parameters, see the table
below.
3. Click Submit to apply your changes.
Parameter
Forward Type
[FwdInfo_Type]
Version 6.6
Figure 26-7: Call Forward Table Page
Table 26-5: Call Forward Table Parameter Description
Defines the condition upon which the call is forwarded.

[0] Deactivate = (Default) Don't forward incoming calls.

[1] On Busy = Forward incoming calls when the port is busy.

[2] Unconditional = Always forward incoming calls.

[3] No Answer = Forward incoming calls that are not answered within
the time specified in the 'Time for No Reply Forward' field.

[4] On Busy or No Answer = Forward incoming calls when the port is
busy or when calls are not answered within the time specified in the
'Time for No Reply Forward' field.

[5] Do Not Disturb = Immediately reject incoming calls.
Description
309
26. Analog Gateway
MP-11x & MP-124