Resetting The Rmc To Factory Defaults - Digital Equipment 3300R Service Manual

Server Management Console
PLATFORM STATUS:
Firmware Revision:
Server Power:
Fanstate:
System Halt:
Temperature: 29.0
RCM Power Control:
Escape sequence: ^[^[RMC
Remote Access:
Modem Password:
Alert Enable:
Alert Pending: NO
Init String:
Dial String:
Alert String:
Modem and COM1 baud:
Last Alert:
Watchdog Timer: 60 seconds
Autoreboot : OFF
User String:

Resetting the RMC to Factory Defaults

If you have forgotten the password, or have changed and forgotten the RMC escape
sequence, you can reset the RMC to its factory settings. Use the following procedure to
restore the default settings:
1. Unplug the system line cord from the AC power line.
2. Open the system side panel.
3. Install jumper J22 on the system motherboard (refer to Figure 8-1).
4. Plug the system line cord into the AC power line for approximately 15 seconds.
5. Unplug the system line cord from the AC power line.
6. Remove jumper J22.
7. Close the system side panel.
8. Plug the system line cord into the AC power line
NOTE: After resetting to default settings, you should complete the first-time setup
procedures to enable remote dial in and call out alerts.
4–8 DIGITAL Server 3300/3300R
V2.0
ON
OK
Deasserted
¡
C (warnings at 46
ON
Enabled
Set
Enabled
at&f0e0v0x0s0=2
atxdt9,15085553333
,,,,,,5085553332#;
9600
RMC User Requested
System 1
¡
C, power-off at 52
¡
C)