Enable Reboot; Enable Remote; Halt In - Digital Equipment 3300R Service Manual

enable reboot

The enable reboot command enables automatic reboot of the system when the watchdog
timer expires. The watchdog timer is enabled and operated by the operating system. It
periodically interrupts the server management microcontroller and assists in clearing a
hung state in the operating system. If the microcontroller does not receive a watchdog
timer interrupt for a specified period of time, it resets the system.
Example:
RCM> enable reboot
RCM>

enable remote

The enable remote command enables access to the RMC modem port. This command also
allows the RMC to automatically dial the phone number set with the set dial command
upon detection of alert conditions. The enable remote command causes the modem
initialization string to be sent to the modem (see set init command).
NOTE: The RMC password must be set for the enable remote command to succeed.
Example:
RCM> enable remote
RCM>

halt in

The halt in command is the equivalent of setting the Halt button on the server front panel
to the latching "in" position. After executing the halt in command, the user is switched
from the RMC monitor to the server's COM1 port. Note that a local operator physically
powering off the system through the system front panel will override this command and
reset the halt command to the "out" condition.
Example:
RCM> halt in
Returning to COM port.
Server Management Console
DIGITAL Server 3300/3300R 4–11