Remote Management Console Commands
The remote management console supports the following commands:
clear {alert, port}
disable {alert, reboot, remote}
enable {alert, reboot, remote}
halt {in, out}
hangup
help or ?
power {off, on}
quit
reset
send alert
set {alert, baud, dial, escape, init, password, wdt}
status
Explanations and examples of the RMC command set follow.
clear alert
The clear alert command clears the current alert condition and causes the RMC to stop
paging the remote operator. If the alert is not cleared, the RMC continues to page the
remote operator every 30 minutes, assuming both remote access and alerts are enabled.
Example:
RCM> clear alert
RCM>
clear port
The clear port command uses the console port modem control signals to clear any "stuck"
conditions on the system's COM1 port. The object is to attempt to free the port using the
COM1 port modem control lines if it is currently locked by some application program
without resetting the entire system.
Example:
RCM> clear port
RCM>
disable alert
The disable alert command disables alert conditions from paging an external operator.
Monitoring continues and alerts are still logged in the "last alert" field; however, alerts are
not sent to the remote user.
Server Management Console
DIGITAL Server 3300/3300R 4–9