Getting Started; Correlating Pc / Mediant 2000 Ip Address & Subnet Mask; Table 3: Mediant 2000 Default Ip Address / Subnet Mask - AudioCodes Mediant 2000 Installation Manual

3

Getting Started

AudioCodes' Mediant 2000 application software already resides in the device's
flash memory when it is supplied (with factory default parameters). Mediant 2000
devices are also supplied with an Embedded (integrally stored) Web Server,
used to configure the device and monitor it during run time. Modifications made
to the Mediant 2000 via the Embedded Web Server (not explicitly requiring a
reset) are "on-the-fly" and do not affect service.
AudioCodes' Embedded Web Server enables Users to:
Set the Mediant 2000 device's IP address & Subnet Mask (refer to Section
3.3 on page 13)
Configure control protocol parameters:
Monitor trunk and channel status (refer to Figure 7-1 on page 19)
Download software updates (refer to Section 9 on page 23)
3.1 Correlating PC / Mediant 2000 IP Address &
Subnet Mask
Before using your Web browser to access the Mediant 2000 device's Embedded
Web Server, change your PC's IP address and Subnet Mask to correspond with
the Mediant 2000's factory default IP address and Subnet Mask, shown in Table
3. For details on changing the IP address and Subnet Mask of your PC, refer to
Windows™ Online Help (Start>Help).

Table 3: Mediant 2000 Default IP Address / Subnet Mask

E1/T1 Trunks
Trunks 1-8
Trunks 9-16
The two IP addresses (one IP address for Trunks 1-8 and one for Trunks 9-16)
Note:
refer to two different modules (AudioCodes' TPM-1100), which reside in the
same board (AudioCodes' TP-1610) inside the Mediant 2000.
Write down the IP Address and Subnet Mask you assign the device. Do the
Note:
same when defining User Name and Password (refer to Section 3.2 on page
13). If the Embedded Web Server is unavailable (for example, if you've lost your
User Name and Password), use AudioCodes' BootP/TFTP Server to access the
device, "reflash" the load and reset the password (refer to the Mediant 2000
User's Manual for detailed information on using a BootP/TFTP server to access
the Mediant 2000).
Mediant 2000
MGCP/MEGACO (refer to Section 4 on page 14)
H.323 (refer to Section 5 on page 16)
SIP (refer to Section 6 on page 18)
IP Address
10.1.10.10
10.1.10.11
12 Document #: LTRT-00904 Rev 001
Mediant 2000
Subnet Mask
255.255.0.0
255.255.0.0