Power Synchronized Unit Connection; Power Cord Connection; When No Power Distribution Units Are Installed - Fujitsu ETERNUS DX S5 Series Configuration Manual

4. Connecting Cables

Power Synchronized Unit Connection

2
When the RMT port is used, connect the connector of the LAN cable to the RMT port of Controller 0 (CM#0)
and Controller 1 (CM#1).
3
Connect the LAN cables of the MNT port to the network of the customer. If the RMT port is used for remote
support, connect the LAN cable of the RMT port to the network for remote support.
Power Synchronized Unit Connection
When using a power synchronized unit for power control, connect the power synchronized unit to the ETERNUS
DX.
Refer to "Configuration Guide (Power Synchronized Unit)" for details about power synchronized units, the
procedure for connecting power synchronized units to the ETERNUS DX, and required settings.

Power Cord Connection

Connect the power cords to the ETERNUS DX.
IMPORTANT
• The controller enclosure and drive enclosure have two power supply units (PSU#0 and PSU#1).
Make sure that the power cords are connected to all the power supply units.
• To help with power cord management and prevent incorrect connections, attach labels to the power
cords and make a note of connection origins and destinations.

When No Power Distribution Units Are Installed

The following procedure explains how to connect the power cords when no power distribution units are
installed.
1
Connect the power cord to the ETERNUS DX.
(1)
Connect the power cord plugs to the power inlets of the power supply units.
(2)
Fasten the plug of the power cord with the release tie.
Wrap the release tie around the power cord and fasten the release tie from either side. Make sure
that the release tie is not loose.
58 Configuration Guide (Basic)