Figure 7: Position Of The Cage Nuts (Front Side Of The Rack, Left Support Upright As Example); Figure 8: Fastening The 2.5" Subsystem; Figure 9: Fastening The 3.5" Subsystem - Fujitsu ETERNUS JX40 S2 Operating Manual

Rack mounting
Ê On the front of the rack, place the screws in the appropriate holes of the
support upright and screw the sliding rails tight at the 19" profiles on the
front.

Figure 7: Position of the cage nuts (front side of the rack, left support upright as example)

Ê Place the cage nuts for fastening the subsystem in the appropriate holes of
the front support uprights.
Ê Put the subsystem on the support angles of the sliding rails and push the
subsystem into the rack as far as it will go.
The following steps can be performed by a single person:

Figure 8: Fastening the 2.5" subsystem

Figure 9: Fastening the 3.5" subsystem

Ê Secure the subsystem within the rack using the two screws on each side.
30 Operating Manual
Installation
ETERNUS JX40 S2