Configuring Link Dependencies - Dell PowerConnect 8024 User Configuration Manual

Command
duplex {half | full |
auto}
size
mtu
CTRL + Z
show interfaces status
show interfaces
configuration
show interfaces advertise View a summary of the speeds that are advertised on each
show interfaces
description
show interfaces detail
interface

Configuring Link Dependencies

Beginning in Privileged EXEC mode, use the following commands to
configure ports that are dependent on the state of other ports.
Command
configure
link-dependency group
group_id
interface
add
452
Configuring Port Characteristics
Purpose
Configure the full/half duplex operation of a given
Ethernet interface, or enable duplex auto negotiation.
Fiber ports must always be configured full-duplex. auto
negotiation is never used on fiber ports.
Enable jumbo frames on an interface by adjusting the
maximum size of a packet.
Exit to Privileged EXEC mode.
Show summary information about all interfaces.
View a summary of the configuration for all ports.
port.
View configured descriptions for all ports.
View detailed information about the specified port.
Purpose
Enter Global Configuration mode.
Enter the link-dependency mode to configure a link-
dependency group.
Add member ports to the group.
interface
The variable includes the interface type and
number, for example tengigabitethernet 1/0/3. You can
also add port channels (LAGs) as members by using the
keyword port-channel followed by an ID.
You can also specify a range of interfaces. For example,
interface tengigabitethernet 1/0/8-10,1/0/20 configures
interfaces 8, 9, 10 and 20.